| Saw Incision Method: |
| Fretsaw: trapezoidal / flat saw blade Incline the teeth of flat saw 45° hard alloy. |
 |
| The diameter of saw blade: 300mm | |
| Number of saw teeth: 72 pieces are used to cut 5 boards Leuco Ref: 188389 | |
| 96 pieces are used to excision the fins Leuco Ref: 188390 | |
| The diameter of saw balde: 250mm | |
| Number of saw teeth: 60 pieces are used to cut 5 boards Leuco Ref: 188939 | |
| 80 pieces are used to excision the fins Leuco Ref: 188940 | |
| Thickness of teeth: 3.0mm | |
| Back angle: 15° | |
| Front angle：+10° | |
| V- Notch Method: | |
| If you want make V-slot in the back of the aluminum composite panel, through the artificial method is easy to mold, use the regulate planer. Incision rate : 3000-5000 meter/ min Feeding rate: 25-30 meter/ min |
 |
| U-Notch Method: | |
| Using the special incision machine with guide board to make U-notch. After the process of V-notch, the aluminum composite panel is very easy for hand operation. |
 |
| Riveted joint Method: | |
Using the usual equipment can rivet and solid fixed, if used outside, the use of heating seals should be taken into consideration. Self-plugging rivet can connect conviently from one direction. |
 |
| Bending: | |
| Operating on flat roof, the bending part can be made very trim. Flat punch, table-flap machine or bending mould are suitable to be the bending equipments. We recommend you to bend with the temperature above 10°C. |  |
| Bolt connection: | |
| Concerning the distortion limitation, Company e≥2D, hole diameter(D) and the distance between the center of the hole and panel edge（e）, is the best calculate method. |  |
| Using the table-flap: | |
| Using the table-flap, the min inside radius: r=15xt (t means thickness of the panel) |  |
| Using trio-press brake: | |
| Comparing to the bable-flap machine, the trio-press brake is fitter for bigger inside radium bending. And if you do it before bending, it can be bended by hand after bending. |  |
| Drilling Method: | |
| It is easy to drill holes on Aluminum composite panel, in order to realize the best effect, we suggest you use special aluminum and plastic drilling machines. Incision angle: 100°- 400° |
|
